Read/Write Management Access (15) - User can access the GUI, and can configure the device. See the CLI Reference Guide for more information. ![]() Read/Limited Write CLI Access (7) - User cannot access the GUI, and can only access some CLI commands that change the device configuration. Read-Only CLI Access (1) - User cannot access the GUI, and can only access CLI commands that do not change the device configuration. If not specified, the level is set to the default value of 15. level privilege-level - Specifies the level for which the password applies.To configure a local password on specific user access levels on your switch, enter the following: SG350X(config)# enable password No matter how the password was entered, it will appear in the running configuration file with the keyword encrypted together with the encrypted password.įollow these steps to configure the enable password settings on your switch through the CLI: When you configure a new enable password, it is automatically encrypted and saved to the running configuration file. You should now have configured the line password settings on your switch through the CLI. ![]() (Optional) Press Y for Yes or N for No on your keyboard once the Overwrite file … prompt appears. (Optional) In the Privileged EXEC mode of the switch, save the configured settings to the startup configuration file, by entering the following: SG350X# copy running-config startup-config Enter the end command to go back to the Privileged EXEC mode of the switch. (Optional) To return the line password to the default password, enter the following: SG350X(config-line)# no password Note: In this example, the password Cisco123$ is specified for the Telnet line.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |